微球动态涂敷状态实时监测光学系统的设计

 介绍了一种可用于实时监测直径0.2～1.0 mm激光核聚变靶球涂敷状态的光学系统的设计，系统采用环形LED照明系统以适合特殊的照明要求，用Petzval型物镜使500 mm处的微球清晰成像于CCD像面上，CCD输出的图像电信号经图像采集卡转换成数字信号，最后该数字信号由计算机进行处理，实现了系统对靶球膜层涂敷作业的自动监控，大大提高了涂敷效率。所设计的系统轴上点最大弥散斑直径为12.6 mm,轴外最大弥散斑直径为15.8 mm，整个视场的像质比较均匀,分辨率较高，对于波长522 nm的光线，场曲和畸变分别小于15 mm和0.012%，像质优良。     

共振光散射法测定环境水样中痕量锡

基于在Tris-HCl介质中,痕量锡对氯酚红-人血白蛋白-十二烷基硫酸钠体系的共振散射光谱有明显的猝灭作用;考察了它们的光谱特征、影响因素和适宜的反应条件;确定了散射光强度与Sn2 的关系,从而建立了测定痕量锡的共振光散射新方法.该法在室温下进行,操作方便,灵敏度高和选择性好.其线性范围为0.2-4.0μg/L,检出限0.12μg/L,用于环境水样中痕量Sn2 的测定,相对标准偏差小于3.1%,加标回收率为95.5%-100.5%,效果良好.     

2-(2-喹啉偶氮)-5-二甲氨基苯胺光度法测定铜

在pH=4.0的磷酸盐缓冲介质中,CTMAB存在下,2-(2-喹啉偶氮)-5-二甲氨基苯胺(QADMAA)与铜反应生成2:1稳定络合物,络合物λmax=580nm,ε=1.14×105L·mol-1·cm-1.铜含量在0.01-0.6μg/mL内符合比耳定律,方法用于环境样品中铜的测定,结果令人满意.     

Al-pillared clays supported rare earths and palladium catalysts for deep oxidation of low concentration of benzene

Al-pillared clays supported rare earths (RE/Al-PILC) are prepared and used as supports of palladium catalysts for deep oxidation of low concentrations of benzene (130-160 ppm). The supports and catalysts are characterized by X-ray powder diffraction (XRD), FT-IR, BET, transmission electron microscopy (TEM) and temperature-programmed reduction (H₂-TPR). The results show that Al-pillaring results in a strong increase in the basal spacing (d_0 0 1) from about 1.2 to 1.8 nm, and an increase in the BET surface area from 63.6 (±3.2) to 238.8 (±11.9) m²/g. Activity tests of deep oxidation of low concentration benzene show catalysts supported on Al-PILC and RE/Al-PILC are obviously more active than that on raw clay. Pd/6% Ce/Al-PILC, in particular, can catalyze the complete oxidation of low concentration benzene at a temperature as low as about 290 °C.     

New ligands for the Fe(III)‐mediated reverse atom transfer radical polymerization of methyl methacrylate

A series of (di)picolinic acids and their derivates are investigated as novel complexing tridentate or bidentate ligands in the iron‐mediated reverse atom transfer radical polymerization of methyl methacrylate in N,N‐dimethylformamide at 100 °C with 2,2′‐azobisisobutyrontrile as an initiator. The polymerization rates and polydispersity indices (1.32–1.8) of the resulting polymers are dependent on the structures of the ligands employed. Different iron complexes may be involved in iron‐mediated reverse atom transfer radical polymerization, depending on the type of acid used. ¹H NMR spectroscopy has been used to study the structure of the resulting polymers. Chain‐extension reactions have been performed to further confirm the living nature of this catalytic system. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2912–2921, 2006     

Surface structures formed by individual adsorption and coadsorption of Mn and Bi on Cu(0 0 1), studied by LEED

We have studied the individual adsorption of Mn and Bi, and their coadsorption on Cu(0 0 1) by low-energy electron diffraction (LEED). For Mn, we have determined the c(2 × 2) structure formed at 300 K, whose structure had been determined by several methods. We reconfirmed by a tensor LEED analysis that it is a substitutional structure and that a previously reported large corrugation (0.30 Å) between substitutional Mn and remaining surface Cu atoms coincides perfectly with the present value. In the individual adsorption of Bi, we have found a c(4 × 2) structure, which is formed by cooling below ∼250 K a surface prepared by Bi deposition of ∼0.25 ML coverage at 300 K where streaky half-order LEED spots appear. The c(4 × 2) structure has been determined by the tensor LEED analysis at 130 K and it is a substitutional structure. In the coadsorption, we found a c(6 × 4) structure, which has been determined by the tensor LEED analysis. It is very similar to the previously determined structure of the c(6 × 4) formed by coadsorption of Mg and Bi, and embedded MnBi₄ clusters are arranged in the top Cu layer instead of MgBi₄. Large lateral displacements of Bi atoms in the c(6 × 4)-(Mn + Bi) suggest that the Mn atoms undergo the size-enhancement caused by their large magnetic moment.     

Germanium growth on Br-terminated Si(1 0 0)

The consequences of Ge deposition on Br-terminated Si(1 0 0) were studied with scanning tunneling microscopy at ambient temperature after annealing at 650 K. One monolayer of Br was sufficient to prevent the formation of Ge huts beyond the critical thickness of 3 ML. This is possible because Br acts as a surfactant whose presence lowered the diffusivity of Ge adatoms. Hindered mobility was manifest at low coverage through the formation of short Ge chains. Further deposition resulted in the extension and connection of the Ge chains and gave rise to the buildup of incomplete layers. The deposition of 7 ML of Ge resulted in a rough surface characterized by irregularly shaped clusters. A short 800 K anneal desorbed the Br and allowed Ge atoms to reorganize into the more energetically favorable “hut” structures produced by conventional Ge overlayer growth on Si(1 0 0).     

冻干溶液的低温显微研究与热分析

利用低温显微系统研究了叔丁醇水溶液降温时的晶体形态,并利用差示扫描量热法(DSC)研究了溶液的反玻璃化结晶。低温显微实验表明:叔丁醇／水溶液结晶形状、大小与叔丁醇的浓度有关,浓度为10％时形成粗大的针状结晶, 有利于升华速率的提高。DSC实验表明:10％叔丁醇／10％蔗糖／水三元溶液的临界复温速率为250℃／min左右。     

蕴涵代数与BCK代数

系统研究 Fuzzy蕴涵代数与 BCK代数之间的关系 ,给出 MV代数与 BCK代数之间的联系 ,建立正则 FI代数和对合 BCK代数的对偶代数     

A nilpotent Roth theorem

Let T and S be invertible measure preserving transformations of a probability measure space (X, ℬ, μ). We prove that if the group generated by T and S is nilpotent, then exists in L ²-norm for any u, v∈L ^∞(X, ℬ, μ). We also show that for A∈ℬ with μ(A)>0 one has . By the way of contrast, we bring examples showing that if measure preserving transformations T, S generate a solvable group, then (i) the above limits do not have to exist; (ii) the double recurrence property fails, that is, for some A∈ℬ, μ(A)>0, one may have μ(A∩T _-n A∩S ^{- n} A)=0 for all n∈ℕ. Finally, we show that when T and S generate a nilpotent group of class ≤c, in L ²(X) for all u, v∈L ^∞(X) if and only if T×S is ergodic on X×X and the group generated by T ^-1 S, T ^-2 S ²,..., T ^-c S ^c acts ergodically on X. Oblatum 19-V-2000 & 5-VII-2001?Published online: 12 October 2001